![]() These can be very tight and tough to remove so often times cutting them makes it very easy to remove. The fabric is usually held in place with a plastic/rubber gimp just like a screen door. If you are looking to remove the fabric, you can cut it off. With your membership you will also receive discounts on products and hundreds of hours of Premium content. By becoming a member, you will have access to our expert’s knowledge. Great question! The ‘Ask an Expert’ section is currently for members of our online community. Which End of the awning tube goes into the motor side Reply Most of the time it isn’t a faulty component, usually it is something simple like the batteries or the fabric rolled up backwards. I would first start with your batteries and make sure they are installed properly and then you can test the voltage to the switch. It can happen by your batteries on the camper being installed incorrectly as well. The only thing that can really cause this is the switch, main voltage coming in got changed or the motor is shorting out. If the fabric starts to roll backward and tucking up on top, then the polarity to the motors is bad. The fabric should always be straight on the top and tucking in from underneath. Once all of the way out and the valance is hanging down, now hit the retract button. To check this, run the awning out all of the way even if this means holding down the retract button. I would first make sure the awning fabric is the correct way and not rolled up backwards by mistake. It is actually very easy to roll the awning up backwards and when you press the button it appears to be going in the wrong direction. Only reserve polarity can cause the awning to roll up backwards. If you have any other questions, please chat, email, or call Customer Service.Īwning started rolling up in reverse direction. When the windings in a motor start to go bad, the performance weakens and causes it to move slow I would check to make sure nothing is bent on the arms or tube that would cause something to bind but it sounds like your motor is on its way out. A lot of time, slow movement and noise are caused by a failing motor. You can spray the track and rollers with a silicone lubricant and see if that helps. The only thing that can be lubricated is the rollers in the track. Is there a way to lubricate them as it rolls well at first but keeps getting slower as it rolls in and at some point I fear it will stop. What is the year, make, and model of your RV?Įlectric awning is slow, squeaks, and may be binding but so far still will roll in. ![]() It turns off after a cycle and you reset it and it works all right. I put a new control board in it and it still does the same thing. I restart the refrigerator or turn it off and on and it starts back up but the minute it cycles off it stays off and I did have a code blinking five times that said it was the gas valve and I checked it and that works properly. Norcold refrigerator keeps turning off after a cycle. If you are interested in becoming a member, please click on the offer below: By becoming a member, you will have access to our expert knowledge. Δ 243 Responses to “What to Do When an Awning Won’t Go In”
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |